Welcome, Guest. Please login or register.
Did you miss your activation email?
Friday 06 December 2024, 07:24:06 am

Login with username, password and session length

Visit the Official Endian Reference Manual  HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  GREEN to network switches
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: GREEN to network switches  (Read 12518 times)
dimicool
Jr. Member
*
Offline Offline

Posts: 6


« on: Friday 23 April 2010, 12:26:15 am »

Hi,
I 'm evaluating the Endian firewall and I get it all installed and it works perfectly when I have 1 PC connected to the GREEN interface.
But when I connect GREEN to my switch, none of the PC's get an IP from the DHCP, nor can I ping when assigning a fix ip.
The setup should be fine since it remained unchanged from before when I was using another firewall. (I just switch the GREEN interface to Endian box)

Is there any config needed  ?

I 'm puzzled ..

thx,

D
Logged
arminf
Full Member
***
Offline Offline

Posts: 56


« Reply #1 on: Tuesday 01 June 2010, 04:04:28 pm »

Dont know if still valid

activate the DHCP Server
if you have a layer +3 switch you might need to enter the little helper entry on the switch

use cross over cable to test switch to FW
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.047 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com