Welcome, Guest. Please login or register.
Did you miss your activation email?
Friday 06 December 2024, 10:49:37 am

Login with username, password and session length

Get the new Updates directly from Endian  HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  Unable to boot Endian after removal of CD-ROM post-installation
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Unable to boot Endian after removal of CD-ROM post-installation  (Read 21807 times)
defrag
Jr. Member
*
Offline Offline

Posts: 3


« on: Tuesday 03 March 2009, 07:12:55 am »

I have a PC with no CD-ROM; I hooked up a CD-ROM to install Endian. Everything goes well, I get Endian setup and configured. Once all the install is complete I remove the CD-ROM and reboot the server.

After removal of the CD-ROM I am unable to load Endian. I get error message similar to this

Mounting tmpfs on /dev
mounting root filesystem with flags noatime
mount: error 6 mounting ext3 flags noatime
well, retrying without the option flags
mount: error 6 mounting ext3
well, retrying read-only without any flag
mount: error 6 mounting ext3
Error opening /dev/console!!!! 2
switchroot: mount failed: 22
Kernel panic -not syncing attempting to kill init
Rebooting in 10 seconds

I am not very familar with Linux; Obviously the problem has to do with the CDROM being removed as when I reattach it Endian boots up fine

Any ideas how to fix this?

note: the harddrive is a SATA drive and the CDROM is IDE
Logged
defrag
Jr. Member
*
Offline Offline

Posts: 3


« Reply #1 on: Wednesday 04 March 2009, 05:41:20 am »

Well I went out and purchased a USB CD-ROM; hooked that up and installed it that way; This seems to have done the trick.

Not the best answer but still a work-around if anyone else runs into this issue.
Logged
necomputer
Full Member
***
Offline Offline

Posts: 15


« Reply #2 on: Sunday 12 July 2009, 04:25:53 pm »

I might have tried something like disabling the drive/IDE port after install. Ideally what you experienced shouldn't be a problem because of how an appliance would usually run.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.094 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com