Welcome, Guest. Please login or register.
Did you miss your activation email?
Wednesday 30 October 2024, 10:34:02 pm

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
14248 Posts in 4376 Topics by 6515 Members
Latest Member: hulteends
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  How to determine if multiple public ip are active on RED interface
0 Members and 2 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: How to determine if multiple public ip are active on RED interface  (Read 10293 times)
HermanTheron
Jr. Member
*
Offline Offline

Posts: 2


« on: Tuesday 01 June 2010, 11:40:40 pm »

Hi guys,

I installed the latest version 2.4, and I'm very impressed. I just struggle with a (somewhat) common issue: port forwarding from multiple public ip address on the RED interface. This is the last hurdle before I can move the system into production.

Basically, I have quite a few public ip addresses that I add to the configuration of the RED interface. I then setup port forwarding from the external addresses on RED to servers in the ORANGE zone. If I use any other address than the primary RED interface address, it does not work. Trying to fault find, I see that when  I run ifconfig, I can only see the primary ip address listed, and not any of the other addresses on the RED interface. Now this makes me to think that since no-one is listening on the other addresses, port forwarding will not work.

Can somebody tell me if I am on the right track? Also, must I be able to see the additional ips when I look at the output of ifconfig? Next question: the web interface says the additional addresses is configured, but where is the loading script so that I can see why it doesn't load the additional ip addresses?

Thanks in advance.

Herman
Logged
HermanTheron
Jr. Member
*
Offline Offline

Posts: 2


« Reply #1 on: Wednesday 02 June 2010, 09:50:35 am »

Aagh, found the problem. It seems that the ADSL router did not liked it when I switched off the old firewall system. After a reboot of the ADSL router, everything is working fine.

Thanks for a great product guys!

Herman
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.031 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com