Welcome, Guest. Please login or register.
Did you miss your activation email?
Wednesday 30 October 2024, 12:30:18 pm

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
14248 Posts in 4376 Topics by 6515 Members
Latest Member: hulteends
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  Outgoing firewall problem?
0 Members and 3 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Outgoing firewall problem?  (Read 12330 times)
srtjase
Jr. Member
*
Offline Offline

Posts: 1


« on: Wednesday 28 November 2007, 04:01:45 pm »

I've just installed the new beta and am having issues with enabling ports in the outgoing firewall.
I can set a new rule, but don't see a way to select a source network/ip or interface. It always defaults to "Any".

...and the rule does not seem to work. For example, I have a service on p81/tcp that I need to allow through the outgoing firewall. Even if I create the rule, I can not pass this traffic through the firewall. If I turn the outgoing firewall off, I obviously have no issues.

If I edit existing rules from the backup I did of my 2.1 installation, I can see a box to select the desired networks,interfaces, etc. Again, when creating a new rule, I do not see this box and can only select the type of source, but not the actual source.

Is this a bug in the new version? Should I revert to 2.1?
Any suggestions are welcome. This is driving me nuts!
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.031 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com