Welcome, Guest. Please login or register.
Did you miss your activation email?
Friday 13 December 2024, 04:29:43 pm

Login with username, password and session length

CLICK HERE for the The official Endian Roadmap and Issue tracker
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  Initial network configuration help
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Initial network configuration help  (Read 12875 times)
xlancealotx
Full Member
***
Offline Offline

Posts: 16


« on: Wednesday 08 June 2011, 01:38:16 am »

Good morning, setting up our 2.3 community and looking for some help from the forum.  This is for a small office with a static IP from our ISP.  Behind is the basic 10.x which is working fine, and I can start the setup.  I also have a backup DSL line being installed for internet redundancy as we have had some outages.  The setup shows Network Interfaces 4 which is correct, so I am wondering what will be the backup.

The green is naturally the 10.x
The red is my primary providers public IP.

Now I see an orange and green and wondering which (or is there another way) to setup that DSL to be a 'failover'.  I would like it to be automatic (maybe even notify) on failover, but what's the best way to go about setting this configuration up.

Thanks.
Logged
speccompsol
Full Member
***
Offline Offline

Posts: 44


« Reply #1 on: Wednesday 08 June 2011, 02:49:25 am »

Go to Network ->
Interfaces ->
Add Interface/Uplink ->
Configure Uplink2 accordingly ->
Go to Uplink/Main ->
Select Uplick2 as backup
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.063 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com