* Home Help Login Register

Welcome, Guest. Please login or register.
Did you miss your activation email?
Saturday 28 December 2024, 05:46:02 pm

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
14262 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Hardware Support
| | |-+  NIC Error		 0 Members and 2 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: NIC Error  (Read 11284 times)
mlaurent
Jr. Member
*
Offline Offline

Posts: 4
« on: Wednesday 05 September 2012, 12:14:44 am »
Hi guys
I'm new here, but I've been using endian for a while now. Today is installed a fresh new endian 2.5.1.
Everything was working fine until the network became too slow, when I check for logs I find this
eth0: excessive work at interrupt
eth0 and eth1 are intel pci-e nics and eth2 is an old pci intel
eth0 and eth1 are using e1000e module.

Now I'm going to change eth0 for a encore pci-e, but i'm not sure if this will solve the problem.
Any help would be appreciated.
Best Regards
Marcelo
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.047 seconds with 20 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com