* Home Help Login Register

Welcome, Guest. Please login or register.
Did you miss your activation email?
Tuesday 24 December 2024, 08:35:37 am

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
14262 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Hardware Support
| | |-+  ATOM N270		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: ATOM N270  (Read 31682 times)
Blueman
Jr. Member
*
Offline Offline

Posts: 2
« on: Saturday 30 January 2010, 06:33:13 pm »
Thinking of buying a lex computer Brik appliance with the following specs
Intel Atom N270 1.6GHz processor
Intel 945GSE + ICH7M (82801GBM)
On board DDRII module 1GB
Two SATA ports with independent DMA operation supported
4* Realtek RLT8111C 10/100/1000 Mbps

Is endian supporting realtek 8111C as well as N270?  NOt so worried about the realtek, noticed other posts on that topic but I am a little bit worried for the N270.
Appreciate comments thanks very much
Logged
danylux
Full Member
***
Offline Offline

Posts: 10
« Reply #1 on: Tuesday 02 February 2010, 06:04:33 pm »
Hello

i have take jetway atom 330 with doughter board 3x eth 10/100.

In total i have 1x eth 8111c + 3x eth 10/100 realtek but i don't remember the name of the chip.

The 8111c work for 5 minute after this time the nic not responding. i have install the driver (the procedure is in other post) all work fine..

i don't have notice if this work with 3x 8111c i have only one.

Bye
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.063 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com