Force specific LAN device to specific uplink?

[Guest]

[phoenixkv]

Hello,

We are trying to set up a LAN that allows us to properly utilize two DSL uplinks because our upload on each one is slow.
--
Local Subnet: 10.1.1.x/24

Uplink1: DSL w/ PPPoE configured and active
Uplink2: DSL w/ PPPoE configured and active
--
We are attempting to get a device at 10.1.1.100 to only utilize Uplink1, and a device at 10.1.1.200 to only utilize Uplink2.

All other LAN devices can pick or choose which they use - makes no difference (or is there even a way to do that?).

Any advice would be greatly welcomed and appreciated!

[StephanSch]

You can set the rule to send them over a special WAN by setting a route (Network --> Routing) with the ip as source and the uplink as gateway.