Welcome, Guest. Please login or register.
Did you miss your activation email?
Friday 01 November 2024, 11:32:12 pm

Login with username, password and session length

Visit the Official Endian Bug tracker  HERE
14248 Posts in 4376 Topics by 6515 Members
Latest Member: hulteends
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  Setup post installation (No DHCP)
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Setup post installation (No DHCP)  (Read 13167 times)
vawwyakr
Jr. Member
*
Offline Offline

Posts: 1


« on: Wednesday 18 February 2009, 01:57:30 am »

I went through the installation from the CD with no issues (well after I switched to the 2.2 RC 3 version as the 2.1.2 version would error out).  It tells me to continue on to the https GUI page after rebooting to complete the setup.  However now after (many) reboots, I cannot get any of my clients to get an IP much less get to the GUI page.  I have logged into the shell and used IFCONFIG to identify the eth0 NIC and assign it the IP that I entered into the installation (since it didn't have an IP initially).  I have then tried to get DHCPD to start up by filling out a config file for it but I can't get that to start at all and I still can't get any clients to negotiate an IP to complete the setup.

I've dug through the posts here and it seems like other people have had similiar issues but nothing seems to fully resolve anything to the point where I can get this running.

Thank you for any assistance!
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.031 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com