EFW Support

Hello All,

I have just gone through the initial configuration of my Endian Firewall and having applied the changes, the system did not come back with the main menu and I am now unable to access via its IP. I have chosen the default 192.168.0.15/24 IP but am wondering if I should have chosen a different IP for my Green network. I have also configured other interfaces as follows:

Green - 192.168.0.15 (eth3)
Blue - 10.0.0.1 (eth0)
Orange - 192.168.10.1 (eth2)
Red - DHCP from Cable Modem (eth1)

I have not plugged anything into the RED interface yet and basically have a cable going from the eth3 (green) adapter to a ethernet switch which is connected to my cable modem. Things were working just fine on my private 192.168.0.x network. Do I need to start plugging the cables into the Endian appliance to make things work? Should I have chosen a different IP for the Green network?

Sorry if I sound a little lost here but networking is not my specialty and would appreciate any help on moving forward with this.

Cheers,
Vin.

Hi Vin,

Can you ping 192.168.0.15 from your internal network?

No, I cannot. I used to be able to but once I went through the configuration wizard and setup all the interfaces, something has been setup incorrectly to now make the Firewall unreachable.

Anyone any ideas...?! :-/

Cheers,
Vin.

Doh!!!! - I just figured the issue out. After I went through the initial Wizard configuration, the Green network got switched over to a different NIC. I figured I would plug the network cable and try all the other interfaces and sure enough, it worked when I plugged into a different card.

Problem solved!  :)

Cheers,
Vin.

Glad to hear it Vin :)