|
Title: Need to force Ethernet to 10Mbs on red Post by: takoateli on Friday 12 December 2008, 01:54:20 am I have a satellite internet connection and the modem only supports 10Mbs half duplex and it's not able to negotiate that properly. I always have to force the downstream appliance to 10Mbs. But I don't see how to do that with Endian. Is it possible? Does it have to be done locally at the command prompt? I don't see any option for that in the web gui.
Thanks! Greg Title: Re: Need to force Ethernet to 10Mbs on red Post by: blobbi on Friday 12 December 2008, 05:42:01 pm Hi,
normaly when your Modem has only a 10mbit ethernet Adapter your Network Card does Autoneogating hope this is written correct if not .... ( normaly your ethernetcard autodetects selfs wich speed is need ) EDIT: you can use ethtool or mii-tool in the shell to check out and set your LineSpeed Title: Re: Need to force Ethernet to 10Mbs on red Post by: john.skinner on Thursday 18 November 2010, 07:36:29 am I have used ethtool to set fixed 100Mbps Full Duplex with autonegotiation off for my RED interface, but it doesn't last through a reboot.
I forgot how to configure it to to last through a reboot. Can anyone point me in the right direction as to where to set this on Community version 2.4.1 Thanks |