EFW Support
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email?
Friday 06 December 2024, 06:30:48 am
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Visit the official Endian Community Mailinglist
HERE
14261
Posts in
4377
Topics by
6517
Members
Latest Member:
Sandro
Search:
Advanced search
EFW Support
Support
VPN Support
IPsec & DynDNS Deadpeer detection
0 Members and 0 Guests are viewing this topic.
« previous
next »
Pages:
[
1
]
Author
Topic: IPsec & DynDNS Deadpeer detection (Read 14968 times)
csaasc
Jr. Member
Offline
Posts: 6
IPsec & DynDNS Deadpeer detection
«
on:
Thursday 06 May 2010, 11:27:19 pm »
hey.
i've got a Problem with the Dead Peer detection of the IPsec Tunnels. I'm using 3 Endian 2.3 to connect betwen our sites.. every Endian has a PPPoE Connection with a dynamic IP Adress.
If FW A reconnects it get a new IP. It restarts the tunnel. But side B doesn't detect the dead Peer and always tries to connect to the old IP. FW B doesn't look up the new IP. I've got to restart the IPsec Service everytime....
any ideas?
Logged
Jasp3r
Jr. Member
Offline
Posts: 1
Re: IPsec & DynDNS Deadpeer detection
«
Reply #1 on:
Wednesday 06 July 2011, 11:39:48 pm »
Does anyone have a fix for this? We are also experiencing this issue.
From what I have tested so far.
IPsec VPNs are connected between 2 sites
We reboot one site and it pulls a new IP.
The site not rebooted shows the VPN is not connected and the log files show that its constantly trying to connect.
After the rebooted site comes back it updated zoneedit properly.
Using Putty I am logged into the non rebooted machine and I continue to check DNS by pinging the remote host. After anywhere from 5-15 minutes its dns updates and it sees the new IP however it does not reconnect the VPN.
It is almost as though the VPN is trying to hang on to the old IP somehow. Infact this will continue trying but never connecting. As soon as I restart the VPN connection on the non rebooted machine the VPN connection establishes instantly.
What is the difference between pressing restart and the restart option that is in the connection?
Is there a way to launch a cron job or anything that once the VPN gets disconnected that it would attempt a restart every 1 minute until the connection is reestablished?
Thank you
Jasp3r
Logged
Pages:
[
1
]
« previous
next »
Jump to:
Please select a destination:
-----------------------------
Announcements
-----------------------------
=> Project News
=> Latest News and Updates
-----------------------------
Support
-----------------------------
=> General Support
=> Installation Support
=> EFW SMTP, HTTP, SIP, FTP Proxy Support
=> VPN Support
=> Hardware Support
-----------------------------
Development
-----------------------------
=> EFW Wishlist
=> Contribute Your Customisations & Modifications
Page created in 0.078 seconds with 18 queries.
Powered by SMF 1.1 RC2
|
SMF © 2001-2005, Lewis Media
Design by
7dana.com