|
Title: EFW 3.2.2 not booting after install Post by: jesus.beltran on Wednesday 05 April 2017, 02:44:10 am Hi,
I'm setting up a new equipment with EFW 3.2.2. Installation goes fine, but as soon as it is completed and the system reboots from HDD, it goes to a black screen with blinking cursor. Nothing else happens. I already tried EFW 3.2.2 and 3.2.1 with the same result. Even swapped hard drives. System Specs are: Gigabyte GA-H81M-H motherboard Pentium G3260 LGA1150 processor 4GB RAM Toshiba SATA-3 500Gb Hard Drive I've disabled the serial port console option at the installation, so I guess this isn't the issue. Anyone has had the same problem before? Any hints? Title: Re: EFW 3.2.2 not booting after install Post by: jesus.beltran on Wednesday 05 April 2017, 04:04:57 am Ok figured this one out. Had to turn off AHCI for SATA on the board's BIOS. That did the trick.
Title: Re: EFW 3.2.2 not booting after install Post by: marziano on Friday 03 November 2017, 09:16:30 pm Ok figured this one out. Had to turn off AHCI for SATA on the board's BIOS. That did the trick. Ok, this worked for me too. But what if you want to use a solid state drive? You need AHCI for TRIM to work. Title: Re: EFW 3.2.2 not booting after install Post by: mmiat on Thursday 08 February 2018, 03:54:25 am me too with 3.2.4
gigabyte GA-C1037UN-EU cpu Celeron 1037U 2gb ram ssd kingston 30GB endian 2.5.2 was running, i tried to update it without success change AHCI to IDE didnt fix Title: Re: EFW 3.2.2 not booting after install Post by: mmiat on Thursday 08 February 2018, 09:39:34 pm i can install endian 2.5.2, but 3.2.2 or 3.2.4 cant :(
Title: Re: EFW 3.2.2 not booting after install Post by: mmiat on Saturday 17 February 2018, 09:11:54 pm it seems ok after disabled uefi
it was "legacy and uefi", it was not good, it's needed "legacy only" Title: Re: EFW 3.2.2 not booting after install Post by: pavo07 on Wednesday 12 September 2018, 06:21:42 am Hi,
Had the same issue. Furthermore I initially thought it was a different situation since I didn't see any cursor blinking, just the black screen and nothing else, but this was later discarded by connecting a different monitor which showed the blinking cursor (resolution issues, you know). In my case, after playing with AHCI/Legacy, UEFI, secure boot and several options from BIOS + several Endian install attempts (versions 3.2.2 to 3.2.5), nothing seemed to work... At the end we installed a Windows System (7) in the machine (HP ProDesk 600 G1) and in the process we found several partitions in the HDD, possibly created by the previous Endian install attempts, such partitions were deleted leaving only one. Windows got installed and we tried Endian install again on this same machine an disk, in this case with successful result: 3.2.5 up and running. Hope this helps others in the community ;) Rgrds! Title: Re: EFW 3.2.2 not booting after install Post by: kkhald on Wednesday 12 September 2018, 08:16:13 pm You sirs.
I hope you wear capes on daily basis. Because those are the advice of heroes |