Welcome, Guest. Please login or register.
Did you miss your activation email?
Saturday 14 December 2024, 09:35:15 pm

Login with username, password and session length

Download the latest community FREE version  HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  Inbound Firewall Configuration
0 Members and 2 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Inbound Firewall Configuration  (Read 6964 times)
shairozan
Jr. Member
*
Offline Offline

Posts: 4


« on: Sunday 18 April 2010, 03:38:25 am »

Hello everyone,

This might seem like a stupid question, but something about the Endian Firewall is baffling my mind. I'm used to working with Cisco devices such as the ASA 5510 and their 2800 routers, and I can't seem to figure out where in the Endian interface the inbound firewall rules are defined. There is an "inbound routed traffic" section, but according to the documentation that seems like it is more appropriately used by organizations with more than one public IP address who do not wish to use NAT.

Basically, I've run into an issue where my VoIP connection can receive incoming calls and make outgoing calls, but only on control ports. No audio is being exchanged. Thus, I wanted to open up the UDP ports on the inbound firewall, but I'm not exactly sure where to do that. Can someone help me out?

Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.063 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com