Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 05 December 2024, 05:05:38 pm

Login with username, password and session length

CLICK HERE for the The official Endian Roadmap and Issue tracker
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  Nice setup now not working
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Nice setup now not working  (Read 15577 times)
joeypesci
Jr. Member
*
Offline Offline

Posts: 2


« on: Thursday 11 December 2008, 11:09:29 am »

How annoying.  I've discovered Endian Firewall and have a spare PC so setup it up to act as one.  Set it up for testing.  Firewall connected to my switch and the other NIC connected to the router.  My PC was connected to the switch.

So firewall (in the RED zone) 1st NIC connected to the router with 10.0.0.2 and the router 10.0.0.1

The other NIC on the firewall is 10.0.1.1 (in the GREEN zone) and connected to the switch.

Once the firewall was booted and connected, my PC could connect to the Internet.  Disable the firewall and sure enough can't get to the Internet.

Was able to get on the firewall console via a browser going to https://10.0.1.1 as my PC is 10.0.1.2 (in the GREEN zone)

So decided to migrate it out of test and into my network.  Now I can't get access to the console at all.  Moved it back to my test area and can't get access to the console there now either.  Reset to factory settings which sets it to 10.0.0.13 and I've set my PC back to 10.0.0.2 and I can get on the console and set everything up again.  Once back to 10.0.1.1 and my PC back to 10.0.1.2 yet again I can't access the console.

I'm confused as it worked fine before.

Pic shows setup


Logged
joeypesci
Jr. Member
*
Offline Offline

Posts: 2


« Reply #1 on: Thursday 11 December 2008, 11:51:26 am »

I wonder if it's switch specific.  I reinstalled it from CD, set it up in the test area and it's working fine again.  But I bet if I move it to the other switch, it won't work.  But then that doesn't explain why when moved back to the switch it was installed on, it doesn't work, possible that when it loaded on the other switch, it corrupts it maybe.

Odd.  I'll see what happens when I move it tomorrow.
Logged
c4lypso
Jr. Member
*
Offline Offline

Gender: Female
Posts: 2


You're Doing it Wrong


« Reply #2 on: Friday 09 January 2009, 08:40:21 am »

I had a similar problem however when I cycled power on the switch and restarted the computers, everything worked again...I was using DHCP so it needed to have the new IP's however that might not be your issue.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.078 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com