Welcome, Guest. Please login or register.
Did you miss your activation email?
Friday 06 December 2024, 08:24:38 am

Login with username, password and session length

The Latest Endian Firewall is now available for download HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  Green connection drops out during boot
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Green connection drops out during boot  (Read 15311 times)
xx
Jr. Member
*
Offline Offline

Posts: 4


« on: Sunday 23 May 2010, 09:35:00 am »

Hello,

I am new to endian and have a issue after a fresh install. I have searched the forum but did not find a similar problem, hope someone can help.

I have just installed endian community 3.2. Install is fine. Then the Green nic gets assigned to another network card, took a few minutes but worked that one out.

So all goes well, install and the initial configuration. Then after about 3 mins the green connection will just drop out and I can not connect to the web admin page again.

I ran a ping 192.168.0.15 -t and reboot endian, around about 20% into the boot it and ping endian, then at about 60% it drop the connection.

I have no idea, can someone please help.

I have endian setup one a PC connected to a switch via the green nic and a laptop connect to the switch so I can access the web admin page ?

any idea would be great
Logged
xx
Jr. Member
*
Offline Offline

Posts: 4


« Reply #1 on: Sunday 23 May 2010, 01:53:43 pm »

Update

I have just re-installed using a different nic. everything was working fine, until i connected a network cable to the red nic. As soon as I did the green dropped out.

I have a adsl modem/router. Which is set to DHCP I connect a network cable into a port on the router then to the red nic, is this correct ?

Not sure why the green drops out when the red is connected
Logged
xx
Jr. Member
*
Offline Offline

Posts: 4


« Reply #2 on: Sunday 23 May 2010, 03:48:59 pm »

Update

Same thing happens with the new nic.

Must be something to do with the modem/router
Logged
xx
Jr. Member
*
Offline Offline

Posts: 4


« Reply #3 on: Sunday 23 May 2010, 04:30:43 pm »

OK, I have it working now.

I set the red to Ethernet static and assigned it an IP address.

Is this correct? Should the modem/router have dhcp on, or is it correct the way I have it ?
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.063 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com