EFW Support
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email?
Wednesday 18 December 2024, 12:54:50 pm
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
The Latest Endian Firewall is now available for download
HERE
14261
Posts in
4377
Topics by
6517
Members
Latest Member:
Sandro
Search:
Advanced search
EFW Support
Support
General Support
Can Endian manage several Public IPs?
0 Members and 1 Guest are viewing this topic.
« previous
next »
Pages:
[
1
]
Author
Topic: Can Endian manage several Public IPs? (Read 8058 times)
dantunes
Jr. Member
Offline
Posts: 1
Can Endian manage several Public IPs?
«
on:
Saturday 30 October 2010, 01:29:26 am »
Hi,
I have currently 5 public IP, and 2 of them are used for LAN-to-LAN VPN with customers. At the moment these 2 VPN routers are not behind a firewall, and I wanted to know if I can use static NAT to keep them behind ENDIAN, but still having their dedicated public IP.
Can this be done, or do I have to setup these VPN's in Endian? How does Endian manage different Public IPs?
Thanks
Logged
alvaroarb
Full Member
Offline
Posts: 13
Re: Can Endian manage several Public IPs?
«
Reply #1 on:
Saturday 30 October 2010, 05:30:12 am »
dantunes
If you want to put the vpn routers behinf endian then you have to :
1- Give both of your vpn routers LAN ip addresses
2- Then configure all your public ip's in your WAN or RED interface (Network --> interfaces --> Uplink Editor --> click on the pencil icon in you NIC then click Add additional addresses (one IP/Netmask or IP/CIDR per line) checkbox an add your additional IP's one per line using CIDR notation ... that in case you didn't do it in your initial setup)
3 - Now you have to NAT each of your public IP's to their respective vpn router : Firewall --> Port forwarding / Destination NAT -->click on 2Add a new Port forwarding / Destination NAT rule" --> on "incoming ip" select the ip you want to NAT, on "Incoming Service/Port" if you know the ports you need then state them, if you don't leave service and protocol in ANY (not really a good idea but it works), on "transate to" type your vpn router's LAN ip address (leave port/range blank), make sure the NAT droplist says NAT and the "enabled" check box is on, click on "Create rule" then apply and you're done ! repeat for the other vpn router.
Hope it helps
Logged
Pages:
[
1
]
« previous
next »
Jump to:
Please select a destination:
-----------------------------
Announcements
-----------------------------
=> Project News
=> Latest News and Updates
-----------------------------
Support
-----------------------------
=> General Support
=> Installation Support
=> EFW SMTP, HTTP, SIP, FTP Proxy Support
=> VPN Support
=> Hardware Support
-----------------------------
Development
-----------------------------
=> EFW Wishlist
=> Contribute Your Customisations & Modifications
Page created in 0.047 seconds with 18 queries.
Powered by SMF 1.1 RC2
|
SMF © 2001-2005, Lewis Media
Design by
7dana.com