EFW Support
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email?
Thursday 05 December 2024, 02:27:00 pm
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Get the new Updates directly from Endian
HERE
14261
Posts in
4377
Topics by
6517
Members
Latest Member:
Sandro
Search:
Advanced search
EFW Support
Support
Installation Support
Unable to boot Endian after removal of CD-ROM post-installation
0 Members and 1 Guest are viewing this topic.
« previous
next »
Pages:
[
1
]
Author
Topic: Unable to boot Endian after removal of CD-ROM post-installation (Read 21715 times)
defrag
Jr. Member
Offline
Posts: 3
Unable to boot Endian after removal of CD-ROM post-installation
«
on:
Tuesday 03 March 2009, 07:12:55 am »
I have a PC with no CD-ROM; I hooked up a CD-ROM to install Endian. Everything goes well, I get Endian setup and configured. Once all the install is complete I remove the CD-ROM and reboot the server.
After removal of the CD-ROM I am unable to load Endian. I get error message similar to this
Mounting tmpfs on /dev
mounting root filesystem with flags noatime
mount: error 6 mounting ext3 flags noatime
well, retrying without the option flags
mount: error 6 mounting ext3
well, retrying read-only without any flag
mount: error 6 mounting ext3
Error opening /dev/console!!!! 2
switchroot: mount failed: 22
Kernel panic -not syncing attempting to kill init
Rebooting in 10 seconds
I am not very familar with Linux; Obviously the problem has to do with the CDROM being removed as when I reattach it Endian boots up fine
Any ideas how to fix this?
note: the harddrive is a SATA drive and the CDROM is IDE
Logged
defrag
Jr. Member
Offline
Posts: 3
Re: Unable to boot Endian after removal of CD-ROM post-installation
«
Reply #1 on:
Wednesday 04 March 2009, 05:41:20 am »
Well I went out and purchased a USB CD-ROM; hooked that up and installed it that way; This seems to have done the trick.
Not the best answer but still a work-around if anyone else runs into this issue.
Logged
necomputer
Full Member
Offline
Posts: 15
Re: Unable to boot Endian after removal of CD-ROM post-installation
«
Reply #2 on:
Sunday 12 July 2009, 04:25:53 pm »
I might have tried something like disabling the drive/IDE port after install. Ideally what you experienced shouldn't be a problem because of how an appliance would usually run.
Logged
Pages:
[
1
]
« previous
next »
Jump to:
Please select a destination:
-----------------------------
Announcements
-----------------------------
=> Project News
=> Latest News and Updates
-----------------------------
Support
-----------------------------
=> General Support
=> Installation Support
=> EFW SMTP, HTTP, SIP, FTP Proxy Support
=> VPN Support
=> Hardware Support
-----------------------------
Development
-----------------------------
=> EFW Wishlist
=> Contribute Your Customisations & Modifications
Page created in 0.063 seconds with 16 queries.
Powered by SMF 1.1 RC2
|
SMF © 2001-2005, Lewis Media
Design by
7dana.com