|
Title: Endian 2.2rc-1 Installation in VMware Fusion Post by: cmateski on Tuesday 20 May 2008, 05:56:16 am Hello, I installed Endian v2.2rc-1 in VMware Fusion on a Mac Book Pro laptop. The installation was successful but I am having difficulty accessing the VM with the Safari browser. I am not sure what I need to do to configure this correctly. I only have 2 network ports .. 802.11G WiFi and Ethernet. I am only interested in testing the new version out. Not putting it into service for the network.
If anyone has suggestions I would be very grateful for the help. Title: Re: Endian 2.2rc-1 Installation in VMware Fusion Post by: jump on Friday 13 June 2008, 07:41:02 am Hi
I did the following, when i was testing some weeks ago: 1) Install 2.2RC1 with one (1) NAT interface (the rest was standard fustion settings..). 2) Gave the Green Interface the adress f.ex. 172.16.0.1/255.255.0.0. in the console-setup. 3) Install finishes - then reboots. 4) I then fired up an allready configured win-vm system, also NAT, and gave it a 172.16.0.10/255.255.0.0 IP 5) Was able to ping 172.16.0.1 - fine 6) power off the efw-vm, add another interface, which is connected diretly to lan (this will be the red on efw...) 7) power on the efw-vm 8:) wait, until it's up and running, i will display the link to the admin-web-gui (https://172.16.0.1:10443 in this case) 9) open a browser in the win-vm and open the link (see point eight) - may take some seconds. 10) finish the setup through web-gui (eg. nic configured unter 6 will be red). 11) Have fun! if you do not have a win-vm, you can download a browser-appliance on vmware-appliances place: http://www.vmware.com/appliances/ regards jump |