EFW Support

I have already Googled this and searched the forums and have seen some answers, but something isn't quite working right and I'd like a little clarification for my specific situation.  I'm also somewhat of a noob at this.

I have been using ClearOS community 6.3 for the past several months and have liked it for the most part, but I have had several glitches with it and wanted to try Endian.  I really like Endian so far and I'm almost ready to switch to it.

In ClearOS, I had three network interfaces.  One WAN, two LAN.  I had it setup as a virtual machine in ESXi, with 3 NICs assigned to it, and two ethernet cables leaving the host and going into two separate switches which disperse into two separate LANs.  The two lan NICS had separate IPs- 192.168.1.1, 192.168.2.1

Modem > Firewall > LAN 1
                            > LAN 2

So on LAN 1, the default gateway was set to 192.168.1.1, and in LAN 2, the gateway was set to 192.168.2.1.  It worked fine this way.  Then I setup rules to prevent LAN 1 and LAN 2 from communicating with each other.

It's not working that way in Endian.  I have already found out I can't have two Green interfaces, so I read that it's okay to just use Orange for a second subnet and setup inter-zone traffic to reject communication between the two.  That's what I want to do.  I have Green setup as 192.168.1.1, and Orange setup as 192.168.2.1.  Green works great, but if I set the default gateway to 192.168.2.1 on LAN 2 PC's, they aren't getting a connection to the internet.  Can I not bridge the connection between Orange and Red while simultaneously bridging Green and Red?

I can ping google.com from LAN 2 on orange, but I can't browse to the page.

Hmm, I tried setting 192.168.2.1 (LAN 2) to the blue interface rather than orange, and everything works great, including my interzone traffic rules.

I read somewhere that even though orange is considered DMZ and blue wireless, that endian doesn't make much functional distinction between the two until the user has defined the settings.