Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 26 December 2024, 03:36:04 am

Login with username, password and session length

Visit the Official Endian Bug tracker  HERE
14262 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  NIC Issues and Speed - Two different machines
0 Members and 2 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: NIC Issues and Speed - Two different machines  (Read 11470 times)
farmeunit
Jr. Member
*
Offline Offline

Posts: 2


« on: Friday 18 November 2016, 02:19:50 am »

I have a Dell R610 server, but when installing Endian, it seems to go fine, but the NIC ports always show DOWN.  The NICs are NetXtreme II BCM5709 Gigabit Ethernet.  I would like to use the server due to power, flexibility, and due to my next issue.

I have a second install on an HP 8200 with Core-i3 and 8GB of RAM.  Using the onboard gigabit NIC and a Realtek gigabit NIC.  Everything seemed fine last night, but this morning, speeds were HORRIBLE, and it seemed to be dropping packets, although I didn't have time to test much.  It would timeout and just typically running slowly.  I just didn't have any extra gigabit NICs to play with, but is there anything else I could look at?  I assume that it just wasn't under load last night, but is this morning.  CPU is down to almost nothing on 4 core and RAM is about 3.5GB out of 8GB.

If I could get my Dell R610 issue fixed, that is my priority.

I am running 3.2.2 on both and have ran efw-upgrade on the 8200.  I tried 3.2.1 and it had same behavior on the R610, but wouldn't even boot on the 8200.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.063 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com