Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 05 December 2024, 08:41:15 pm

Login with username, password and session length

Visit the Official Endian Reference Manual  HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  SNAT Issue
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: SNAT Issue  (Read 7803 times)
syd05
Jr. Member
*
Offline Offline

Posts: 1


« on: Saturday 21 November 2009, 09:19:08 pm »

Hi,

I'm trying Endian Firewall for the first time and have installed EFW 2.3 Community Edition. The problem I'm facing is with NAT. I have multiple servers in my network for which I want to enable SNAT / DNAT. My concern is with SNAT since DNAT works fine. Having configured the rules, I find  that the system rule only seems to take effect and hence my servers behind the firewall end up using the Primary Public interface IP though it has a specific IP that it is configured to use. A listing of iptables -t nat -nvL shows the packet count as 0 for the specific SNAT rule in question

I've tried disabling the transparent proxy for this IP and found the packet count in iptables increasing ( SNAT rule ); but am not able to surf any websites though ideally I should be able to. I'm quite conversant with iptables concepts but seem to be missing out on some thing very fundamental here perhaps. Assistance would be appreciated.

--Syd
Logged
jbrent
Jr. Member
*
Offline Offline

Posts: 3


« Reply #1 on: Friday 11 December 2009, 07:28:18 am »

Did you ever find a solution to this?

I'm having a similar problem as well...
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.063 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com