Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 05 December 2024, 02:40:50 pm

Login with username, password and session length

CLICK HERE for the The official Endian Roadmap and Issue tracker
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  Pls advise me how to set the VLAN in Endian 2.5
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Pls advise me how to set the VLAN in Endian 2.5  (Read 22512 times)
ducvt
Jr. Member
*
Offline Offline

Posts: 3


« on: Wednesday 29 May 2013, 12:22:38 pm »

Dear All,
I have 2 interfaces in my endian FW 2.5.1 community version.
One is used for WAN (connected to ADSL Router) and other to the local network. I have segregated the network using VLANS on the switch Cisco (2 VLANS) VLAN 16:172.16.x.x, VLAN 17:172.17.x.x
Problem is when connect Cisco Switch to Green interface(172.16.1.1), Endian only detected ip from VLAN, can not see ip from VLAN 17.
Please advise me, how to config on Endian or Switch for Endian can detect and manager both VLANs?
Logged
ducvt
Jr. Member
*
Offline Offline

Posts: 3


« Reply #1 on: Thursday 30 May 2013, 08:03:04 pm »

Nobody can help me Huh
Logged
Syntax42
Full Member
***
Offline Offline

Posts: 19


« Reply #2 on: Thursday 30 May 2013, 10:58:43 pm »

Why do you have a VLAN?  They segregate your network, which makes it so devices can not talk to each other without being routed.

In order for EFW to route traffic from a VLAN, it must have an IP address inside the VLAN's network.  The only way to achieve this that I know of is to add a third network interface.  You could try adding an extra IP address to the green interface, then bridge the two greens together, but that goes beyond my knowledge of Linux.
Logged
ducvt
Jr. Member
*
Offline Offline

Posts: 3


« Reply #3 on: Wednesday 05 June 2013, 02:38:18 pm »

Thanks for your advice, we have VLAN because we have 2 groups in LAN and i dont want they talk to each other(avoid packet sniffer in LAN) , any suggestions about that?
Logged
juddyjacob
Full Member
***
Offline Offline

Posts: 64


« Reply #4 on: Friday 30 August 2013, 05:03:43 am »

Endian does support VLans under Network, Interfaces, VLAN.  You do need to have the switch port in trunk mode otherwise you will lock yourself out.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.078 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com