cannot install Endian 3.0 on Hp proliant DL380p G8

[Guest]

[Rotich]

Iam trying to install Endian 3.0 on HP proliant DL380p g8 but flashes a blue screen when it reaches select language page and does not proceed.what is the workaround?

[mmiat]

me too, are you installing from usb? installing from cd solved it

[Rotich]

Am installing from a CD

[mmiat]

press alt+f2 so you can see console, maybe there is some warning

[Rotich]

when i press alt+f2 i get the error
module usbhid not found
mounting none on /proc/bus/usb failed device or resource busy
running command /bin/mountsource.sh

[Neo]

Hie

What type of a HDD controller is on that server? Is the drive a SATA drive?

If SATA, please access your CMOS setup and change the SATA mode to AHCI and then restart the setup. It should go past the current blue screen.

[Rotich]

After changing from SATA to AHCI i can go past the blue. From there i cannot proceed, i get the error  Error reading target_device.Your hard disk is too small

[jomoryja]

That probably means that your harddisk controller is not recognized so Endian does not see a harddisk to install onto.