|
Title: Unable to ADD second Uplink EFW 3.0 Post by: mr_tyl3r_durd3n on Saturday 22 March 2014, 10:31:39 pm Hi ,
Is impossible to add any uplink to my fresh and new efw communty 3.0 (vm on ESXi 5.1 U1) If i try to add a Gateway uplink , or a PPPoE connection , alway get this message: Could not Enable Uplink. Device ethX is already used by Main uplink Since yesterday same configuration work fine whit 2.4.1 efw community version on a fisica machine. P.S. Also try 2.5.1 or 2.5.2 , i can get second uplink but is always on "FAILURE" Any one get this problem ? Title: Re: Unable to ADD second Uplink EFW 3.0 Post by: mr_tyl3r_durd3n on Wednesday 26 March 2014, 11:29:19 pm Hi ,
We had EFW 2.4.1 running for 3 years , whit RED on eth0 and Green on eth1 double uplink : Primary "Active" SHDSL "Ethernet Static" Secondary "Active" ADSL "PPPoE" using same RED interface eth0 Whit EFW 3.0 is not possible to using this configuration also is not possible to add a "Gateway" Could not Enable Uplink. Device ethX is already used by Main uplink If we try to add a new eth2 get always same : Could not Enable Uplink. Device ethX is already used by Main uplink After made some test , I get this up to 2.4.1 is possible to use same eth interface / same vlan to make two indipendent uplink ( one Ethernet, one PPPoE) from 2.5.1 - 3.0 is not possible Solution is ad an extra eth interface , whitout endian configuration ( not green , not blue not orange assign) and use it only to configure extra uplink ( Ethenet Static o PPPoE) Still have the Uplink using gateway problem ( 2.5.1 get always Failure status , from 3.0 Could not Enable Uplink. Device ethX is already used by Main uplink) |