EFW Support

I have just installed 2.2 RC2 on one computer and the installation went fine, no problems.
The initial setup done in the web GUI also went fine without any problems, the system reboots and then I tried to log in to the web GUI but cannot log in.
I tried the “admin” as username and “my password” as password but I will not get access.
The system is connected to a network switch, the same switch as the computer that I tried to log in  from is connected to, I can ping the system but is not allowed to log in.
I´ve seen that there are users that have had this problem but I have not found any solution to it.
My system is set up with one Green (192.168.97.1), one Red (DHCP) and one Orange (192.168.98.1) interface

Try:

Username: admin
Password: endian

Your sugestion to use admin and endian was correct but it seems like your not aloud to change the login password in the 2.2 RC2, strange limitation/bug.

I'm having the same problem and have found this thread and one other related to this and tried all suggestions and its not working.  I have already re-installed once. 

Having same issue. Installed, set IP, went to GUI first time, ran through setup (including setting my admin and root password). After completed trying to access the admin GUI with my password or 'endian' fails. Have tried rebooting, multiple installs, no dice.

Anyone got this to work? Is this only happening on a handful of installs? Maybe a specific hardware is causing it?

Had same problem on pushing enter by changing password. By using button with mouse I had no problem. Sounds curious, I know.

Try solution 2 here: http://kb.endian.com/entry/45/