|
Title: Gateway out of the network segment Post by: tharude on Thursday 22 November 2007, 08:17:29 am Hi all,
Today i gave a try on 2.2-Beta1. A lot of work seems to be done with multiple uplinks. But there was one thing missing. I hope that you'll agree with me on this subject, that if you ever need to put a gateway out of your network segment, it is impossible to be done. It will be nice if there is opportunity to add a single host in your routing table and put it as gateway after that. Something like: step one: route add -host 192.168.1.254 eth3 step two: ping the interface to see if it is step three: route add default gw 192.168.1.254 When i've tried to make this by hand, all i've seen in the logs is that gw is out of my network segment and since it can't be pinged it went immediately down. Since it is still Beta, it will be really nice to see such an option in the release. Another thing came up in to my mind, all the time spent to play with MANGLE table with squid enabled was not totaly wasted. One thing i can advice, when you mark a packet e.g. 0xc8 and want to route it via certain uplink interface you must add by hand in your squid.conf the following: tcp_outgoing_tos 0xc8 tcp_outgoing_address 192.168.0.2 killall -9 squid & /usr/sbin/squid -D so the packet can be properly masked and routed via pointed interface. Any idea how to acheive this automatically? Best regards! |