Welcome, Guest. Please login or register.
Did you miss your activation email?
Friday 06 December 2024, 04:08:15 am

Login with username, password and session length

Visit the Official Endian Reference Manual  HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  VPN Support
| | |-+  IPSec / RoadWarrior Instructions (that works)
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: IPSec / RoadWarrior Instructions (that works)  (Read 16197 times)
danknowsit
Jr. Member
*
Offline Offline

Posts: 2


« on: Wednesday 11 August 2010, 02:00:29 am »


So, I am playing around with EFW 2.4 community version as a possible system to use in one of our clients production networks. However, and embarrassingly, I can not get any IPSec RoadWarrior to connect using IPSecuritas from a MAC or even using TheGreenBow on a WinOS system. I have followed the instructions both from the EFW side and from TheGreenBow, and it just does not want to work - while I do not have problems connecting to other IPSec and OpenVPN boxes.

The setup is basic and nothing strange has been done. I did remove all the outgoing rules and just added a single anything out is accepted. I thought perhaps my clients ISP was doing something funky on the DSL modem, but its in totally pass-through, firewall disabled, nat disabled and using a static public IP.

I am sure that I am missing something very stupid - since CheckPoint and Cisco had never been this hard to get working for remote users.

Thanks,
Dan
Logged
vzderic
Jr. Member
*
Offline Offline

Posts: 1


« Reply #1 on: Tuesday 17 August 2010, 01:54:30 am »

Try this:

Enable VPN firewall
Add new rule to ALLOW ANY source to ANY destination

KR.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.078 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com