EFW-2.4-RESPIN

[Guest]

[anvaruk]

Just noticed this new iso image on sourceforge EFW-COMMUNITY-2.4-201005280528-RESPIN.iso

any ideas what's been fixed?
release notes do not say anything

[mrkroket]

Probably the problem with SATA/SCSI drivers at boot

[anvaruk]

Probably the problem with SATA/SCSI drivers at boot

yes, it does work now

[endian-christian]

Just noticed this new iso image on sourceforge EFW-COMMUNITY-2.4-201005280528-RESPIN.iso

any ideas what's been fixed?
release notes do not say anything

As already mentioned above it was mostly the SATA/SCSI Controller recognition. The IPsec GUI has also been modified.

On a side-note... actually it was not the case that we hadn't included the drivers in the kernel... quite the contrary - there were too many drivers... this led to a situation where these drivers would override the actual driver and therefore the hard disks could not be recognized... sometimes strange things happen... Sorry again...

Christian

[smyunus]

Hi,

I am downloading EFW-2.4-RESPIN for setting up after I had a bad experience in EFW 2.3.0, where I was unable to connect to internet thru PPOE. I am afraid that whether I would face the same in 2.4 too.  Also I would like to inform you that during my 2.3.0 installation everything went fine, except my uplink failed to connect. I was really wondering, when the same MODEM, cable, and credentials provided by ISP works fine in my IPCOP firewall. In EFW 2.3.0, I could see the RED interface was up in the dash board, but it never connect to internet at all. Am I missing anything during network configuration. Hope you guys could help me on this matter.

Thanks in advance.

Regards
Yunus