Dashboard Network Information always shows NaN after paravirtualization

[Guest]

[gdampf]

I created a Xen 4.1 DomU (hvmloader) and installed Endian 2.5.1 - all worked well, but slowly.

To improve performance, I switched to a PAE-Kernel:
>efw-upgrade
>2
>x@y.de
>smart install kernel-PAE

I changed the Xen-Settings to pygrub and netfront-ethernet-interfaces, so the endian DomU is starting paravirtualized and working well (I think pretty much faster than before).

/etc/businfotab is nor showing:
# Generated by ethconfig
eth0    XEN-eth0
eth1    XEN-eth1
eth2    XEN-eth2

But since I switched to paravirt. no Network Informations are shown anymore - just "NaN".
The same procedure worked well with Endian 2.4.1 !

I've seen, that the daemon collectd is now (2.5.1) using netlink plugin instead of interface plugin - may be this is the reason for the different behaviour compared to 2.4.1, but I am not such familiar with this details.

Has somebody managed to run Endian 2.5.1 paravirtualized and keeping the Network Information Dashboard workin?

It would be nice to share the configuration.

[Begarin]

Its really sad to see that noone has assisted with your question.  Unfortunately I'm no help, however I confirm that the latest 3.3.0 ISO version was working fine...until I did a command line efw-upgrade (which completed OK) then I got the Status Traffic graphs stopped working and the interface stats above show NAN.  Have rebooted. Have reloaded the upgrade.