|
Title: NIC Error Post by: mlaurent on Wednesday 05 September 2012, 12:14:44 am Hi guys
I'm new here, but I've been using endian for a while now. Today is installed a fresh new endian 2.5.1. Everything was working fine until the network became too slow, when I check for logs I find this eth0: excessive work at interrupt eth0 and eth1 are intel pci-e nics and eth2 is an old pci intel eth0 and eth1 are using e1000e module. Now I'm going to change eth0 for a encore pci-e, but i'm not sure if this will solve the problem. Any help would be appreciated. Best Regards Marcelo |