Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 05 December 2024, 07:05:53 pm

Login with username, password and session length

Visit the Official Endian Reference Manual  HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Hardware Support
| | |-+  Restore backup on new serveur
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Restore backup on new serveur  (Read 24452 times)
ehermouet
Full Member
***
Offline Offline

Posts: 21


« on: Thursday 15 March 2012, 02:45:36 am »

Hi all,

we have new server and we want to migrate endian to new serveur.

i have imported my backup on new serveur but the br0 is not connect to the hardware network card.

it's endian 2.5

tks for help
Logged
tmedcalf
Jr. Member
*
Offline Offline

Posts: 4


« Reply #1 on: Monday 13 August 2012, 11:21:14 pm »

Restoring a backup to new hardware and migrating Endian hard drive to new hardware. 2.5.1

This is quicker and requires less trial and error if you already know the mac address of the network card you want to use for the green interface (br0) and have it documented.

 

Boot the new install.

 

select 0 at the command prompt

[firewall]: 0

[firewall]: login

root's password: XXXXXXXXXXXXX

 

 

If you know the mac address of the adapter you want to use for the green interface (br0) you will want to find the eth# for the adapter run the following command and get the eth#. if you do not have the mac address take note of the eth#'s.

 

If you have the mac address of the network card you want to use for your web interface, use the command:

ifconfig | grep XX:XX:XX:XX:XX:XX (XX:XX:XX:XX:XX:XX represents the mac address you are looking for)

The output should look something like this:

eth6      Link encap:Ethernet  HWaddr XX:XX:XX:XX:XX:XX

In this output we can see that the network card we are looking for is eth6.

If you do not have the mac address:

ifconfig | less

When you have the information you need enter the command:

nano /var/efw/ethernet/br0

Change the number of eth? to whatever eth# your mac address dictated. If you did not know the mac address you will need to sequentially try the eth numbers that you retrieved "ifconfig -a | less" until you find the correct one. You will have to save your change and exit nano then reboot after each change to try the new network card configuration.

Once you get access to the web interface, login and run the "Network Configuration" wizard to configure the network cards.

I have done this, it does not seem to affect the other services and should no, since they are mapped to the bridged network interfaces
Logged
chutawat
Full Member
***
Offline Offline

Posts: 13


« Reply #2 on: Friday 23 November 2012, 06:40:49 pm »

 Grin It's  worked   Cheesy
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.078 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com