VPN question

[Guest]

[Uriel]

Hi,

I am currently using efw 2.4.1 community. I enabled the VPN service but I chose not to bridge it to my GREEN (192.168.1.0/24) network. With this, I created a particular subnet (192.168.10.0/24) for the VPN connection.

I installed an OpenVPN client on a separate computer not belonging to my green network. This computer has its own internet access. I am able to connect to via VPN and is receiving an IP 192.168.10.2. The ip 192.168.10.1 is assigned automatically to the endian server. While being connected to the VPN, I am able to access the endian page and configure it as I wish.

Now, my concern is, I wish for my VPN subnet (192.168.10.0/24) to be able to access the my GREEN subnet (192.168.1.0/24).

THESE ARE WHAT I HAVE DONE SO FAR:

• under FIREWALL > SYSTEM ACCESS, I created an entry, 192.168.10.0/24 > ANY > ANY > ALLOW w/ IPS
• under FIREWALL > VPN TRAFFIC, I created an entry, ANY > ANY > ANY > ALLOW.
• I also created a STATIC ROUTE entry TO and FROM the two subnets using the green IP of my efw server as the stativ Gateway.

With this setup, I cannot ping any of my VPN IP while I'm connected via GREEN and vice versa.

Any enlightenment or help with what I am trying to acomplish will be greatly appreciated.

[dda]

I am currently testing openvpn and I find that I am getting the subnet of my home network when I am connected to the VPN which is a completely different subnet.  It seems that the addresses that I am pushing are not being received on the client side.  Let me know if you figure this out.