Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 05 December 2024, 05:26:31 pm

Login with username, password and session length

Download the latest community FREE version  HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  Outbound traffic to show DMZ IP instead of firewall's uplink IP?
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Outbound traffic to show DMZ IP instead of firewall's uplink IP?  (Read 10164 times)
bangsters
Full Member
***
Offline Offline

Posts: 34


« on: Sunday 27 November 2011, 06:40:50 am »

Hi.

We are using incoming routed traffic to route our multiple public IPs to our DMZ zone.  It's working fine on this part.

However, for the outbound traffic, all traffic coming from our servers in the DMZ are reflecting the firewall's main IP.  How can we change this such that all outbound traffic from DMZ to RED interface reflect the IP of that particular server?

Please advice.

Thanks
Logged
shadowbranch
Jr. Member
*
Offline Offline

Posts: 1


« Reply #1 on: Tuesday 29 November 2011, 12:50:25 am »

Go to firewall then to the source nat tab. Under that you can enter an IP or IP range that should be masked or source natted to a specific ip. Just set the destination to be your main uplink or any uplink.
Logged
bangsters
Full Member
***
Offline Offline

Posts: 34


« Reply #2 on: Tuesday 29 November 2011, 02:14:09 pm »

Thanks!!!  Got it working.

On a side note, how do I enable system access to certain mac addresses only??  From the firewall -> system access menu, it shows that the source can be IP or MAC.  But I tried entering my laptop's mac address.... but it did not work.

any advice?  I need to be able to access firewall via mac address in case of emergency when I'm on an unknown network.
Logged
red
Jr. Member
*
Offline Offline

Posts: 1


« Reply #3 on: Sunday 11 December 2011, 04:43:55 pm »

Hi.

We are using incoming routed traffic to route our multiple public IPs to our DMZ zone.  It's working fine on this part.

Thanks

Hy every body every where;

I'm trying since two days, to route traffic from red to DMZ without success Sad
How you did it, which rule should be applied it ?

We've got a modem/router ---> EFW ---> DMZ


The other thing, is there a possibility to monitore EFW from RED zone (from Internet).
Which rule(s) should be applied ?

Thanks a lot, our EFW is in a production and we are little bit frustating since we are not able to do such things .

Thanks again

red
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.078 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com