Where is the file of the configuration of the network?

[Guest]

[bug.0]

Hi guys. I like create a virtual interface of network in Endian, but I don't find the file of the configuration of the network. Somebody know where is this file?. I searched in the directories of Endian but i didn't found it. Also I did searched in the forum, but I didn't found it

Anyway, change the file of the configuration of the network is the best method for create a virtual interface of network?. This can produce fails in the firewall?.

Sorry if I haven't explained good, or the possible mistakes grammatical.

[juddyjacob]

not sure what you are trying to do, but check out

/var/efw/ethernet/settings
/var/efw/ethernet/br0

also you can search like so "find / -name br0"

might help you find what you are looking for, but if you are trying to setup VLans, you can do it right from the console, again, not really sure what you are trying to do.

[bug.0]

Thanks for answer, but I haven't found the file yet. The file that I search is "/etc/network/interfaces" if this S.O was Debian, or  "/etc/sysconfig/network-scripts" if was RedHat.

I want create a interface virtual, add a second ip address to interface physical.

[juddyjacob]

Pretty sure Endian is based off of RedHat, but anyway, I am assuming you want to do more than just duel IP the interface, which can be done from the network > interface tab. Or system > network configuration.  That's about all I can add , sorry

[bug.0]

I'll try it more later. Thanks again .

[bug.0]

Doesn't work. I need the virtual interface of network before of start configuration. If I have only one interface of network, I can't close the configuration of network, as I need one interface for green zone and other interface for red zone.

My real idea is install Endian in XenClient, a hypervisor type 1, and later install my Debian. For this I need a virtual interface, as only I have a one interface of network.

[mmiat]

if you want to install Endian as a guest in a virtual environment you have to add a virtual network card in virtual host (e.g.: in XenClient) not in Endian

[bug.0]

Can't create a virtual network interface in XenClient, but yes in Xenserver (I only have XenClient).

I found the solution for my problem. I was only had a network interface, I believed that the only solution for this was to create of a virtual network interface. But I didn't saw that in the assistant for configuration the red network there was an option that permitted appoint the gateway as red network.

Sorry for this fail for wasting your time, I was blind with create a virtual network interface :/