Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 12 December 2024, 10:14:38 am

Login with username, password and session length

Visit the Official Endian Reference Manual  HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  EFW Installation on ML110 G8
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: EFW Installation on ML110 G8  (Read 23964 times)
Neo
Jr. Member
*
Offline Offline

Posts: 6


« on: Tuesday 15 July 2014, 07:59:22 pm »

I am trying to install the latest EFW Community Edition on a HP ML110 G8 and after booting up, the installation cannot detect the CDROM to proceed with the installation.

Any smart ways out of this and afterwards, will it see the HDD and NIC's?
Logged
mmiat
Sr. Member
****
Offline Offline

Gender: Male
Posts: 236


WWW
« Reply #1 on: Wednesday 16 July 2014, 06:48:26 pm »

I installed on ML110 G5, no problem when installing but sometimes it freezes. I tried on 2 ML110 G5.
you can try to install from usb storage or from usb cdrom.
Logged

---------------------
IT Consultant
www.fsw.it
Hardware & Software
Neo
Jr. Member
*
Offline Offline

Posts: 6


« Reply #2 on: Tuesday 22 July 2014, 03:58:59 pm »

Thanks.

Will try using an external (usb) CDROM and see if I can get past this first error. I am still worried about the HDD since they may be sharing the same controller. Will update the post later on today if I succeed.
Logged
Neo
Jr. Member
*
Offline Offline

Posts: 6


« Reply #3 on: Tuesday 22 July 2014, 09:10:59 pm »

The external ROM works but it gets to a point where it just flashes a blue screen and does not proceed. On Alt F3, I am seeing an error to do with USB ports not being detected  and a "FATAL - 82152 module not found" error.

Is this a known error and what is the workaround?

Logged
Neo
Jr. Member
*
Offline Offline

Posts: 6


« Reply #4 on: Thursday 02 October 2014, 09:50:47 pm »

Peeps

I finally solved this problem.

If your installation of EFW 3.0 boots to the BLUE screen and flickers there, consider getting into your setup and changing the SATA mode to ACHI. I did this on an ML 310 G8 server and it's up and running now. All the best and easy securing ! ! !
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.078 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com