Welcome, Guest. Please login or register.
Did you miss your activation email?
Monday 23 December 2024, 03:01:33 pm

Login with username, password and session length

Download the latest community FREE version  HERE
14262 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  Help Installing VMtools on EFW 2.4
0 Members and 5 Guests are viewing this topic. « previous next »
Pages: 1 [2]  All Go Down Print
Author Topic: Help Installing VMtools on EFW 2.4  (Read 44973 times)
wheelz
Full Member
***
Offline Offline

Posts: 15


« Reply #15 on: Friday 10 September 2010, 09:22:53 am »

I do have the same problem.  Those commands will rename them to eth0 and eth1 but I can't get it to persist reboots.  I tried the config files from the link you had but no dice.

However even after renaming them I still have to use the rmmod and modprobe commands before the networking will start working.  I think it comes down to the boot messages I get where insmod can't find \lib\vmxnet3.ko.  What's weird is I tried copying those files to that location and allowing full permissions but it still gives the same message.
Logged
wheelz
Full Member
***
Offline Offline

Posts: 15


« Reply #16 on: Thursday 04 November 2010, 01:13:33 pm »

In case anyone else needs to do this, I tried this again and found out what I was missing.  It was simple enough solution that it was rather annoying that it took this long.  Anyway after you get vmtools installed, shut down, swap out the E1000 vNICs with the vmxnet(3) vNICs, boot up, reset the endian box to factory defaults, reboot, and re-run the initial web configuration.  This obviously will only work well if you are doing a new install but I think this only will have to be done once.  Also you should add this line to /etc/init.d/rc.local so the vmware tools services start:

/etc/rc.d/init.d/vmware-tools start

I didn't even need the fix-nic.sh or fix-startup.sh scripts when I did this.  You still have to do all the steps above to get vmtools installed though (editing vmware-install.pl/vmware-config-tools.pl/vmware-uninstall-tools.pl, installing all the dev tools, etc.). 
Logged
Pages: 1 [2]  All Go Up Print 
« previous next »
Jump to:  

Page created in 0.063 seconds with 20 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com