* Home Help Login Register

Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 31 October 2024, 10:24:32 am

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
14248 Posts in 4376 Topics by 6515 Members
Latest Member: hulteends
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  howto qos endian 2.3		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: howto qos endian 2.3  (Read 13325 times)
lirees
Jr. Member
*
Offline Offline

Posts: 8
« on: Friday 30 October 2009, 06:07:35 pm »
where I can find a howto to configure QoS with endian 2.3 ?
Logged
bayross
Full Member
***
Offline Offline

Gender: Male
Posts: 23
« Reply #1 on: Friday 30 October 2009, 11:30:12 pm »
So far I have found NO documentation, but it is quite simple to setup.
First set up a device (the uplink RED interface) and then it automatically configures the classes and after that all you have to do is setup the rules and configure the priorities, etc.
Let me know if you need further help with this.
Garrett
Logged
shalib2
Jr. Member
*
Offline Offline

Posts: 8
« Reply #2 on: Friday 17 December 2010, 09:47:45 pm »
 i have some doubt regarding Qos ,

i have 2 Ethernet cards - red ( wan ) and green ( Lan) , i have 4Mbps connection and i need to limit the bandwidth 1Mbps  to some ips ( 10.1.1.1- 10.1.1.50)  is it possible?? please help me sir.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.047 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com