Command to Permanently Change GREEN IP?

[Guest]

[jinizishuai]

Hi there,

I had similar problems of this earlier post:  efwsupport.com/index.php?topic=414.0 (sorry that I am not allowed to post clickable links)

However, I don't seem to find the "setup" command under my 2.4.1 EFW installation.

I could do "ifconfig br0" but this does not survive a reboot.

There must be some configuration files that is used to store the GREEN IP address unfortunately I don't find the typical /etc/sysconfig/network-scripts/ifcfg-<dev> files.

Could anyone help me here?
Thanks a lot.

Shi

[jinizishuai]

I've finally found it in /var/efw/ethernet.
This should do the work.

[leandroscar]

Answering the question,
The file is located in / var / EFW / ethernet / settings
Make changes to this file and restart the equipment
and ready

[trymes]

Wouldn't it make more sense and be easier to use the "Network Configuration" link on the "System" page of the Web interface? It's the link just below "Dashboard" and it will walk you through the network setup.

The only gotcha I found was that the wizard will allow you to enter configuration settings for the RED interface, but the Uplinks entries under "Network - Uplinks" will take precedence over watever you enter in the wizard.

Tom

[tadaog]

There's a BIG CATCH in doing this by the Network Configuration Wizard, it can only be done completely, so it restarts the configuration and in the meantime, IF WE ARE outside, we lost connection, and if an error occurs, we cannot connect again! So the manual method is much more secure.