|
Title: NIC Issues and Speed - Two different machines Post by: farmeunit on Friday 18 November 2016, 02:19:50 am I have a Dell R610 server, but when installing Endian, it seems to go fine, but the NIC ports always show DOWN. The NICs are NetXtreme II BCM5709 Gigabit Ethernet. I would like to use the server due to power, flexibility, and due to my next issue.
I have a second install on an HP 8200 with Core-i3 and 8GB of RAM. Using the onboard gigabit NIC and a Realtek gigabit NIC. Everything seemed fine last night, but this morning, speeds were HORRIBLE, and it seemed to be dropping packets, although I didn't have time to test much. It would timeout and just typically running slowly. I just didn't have any extra gigabit NICs to play with, but is there anything else I could look at? I assume that it just wasn't under load last night, but is this morning. CPU is down to almost nothing on 4 core and RAM is about 3.5GB out of 8GB. If I could get my Dell R610 issue fixed, that is my priority. I am running 3.2.2 on both and have ran efw-upgrade on the 8200. I tried 3.2.1 and it had same behavior on the R610, but wouldn't even boot on the 8200. |