Welcome, Guest. Please login or register.
Did you miss your activation email?
Thursday 05 December 2024, 02:40:31 pm

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
14261 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  Can not access to IP defined during installation
0 Members and 2 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Can not access to IP defined during installation  (Read 9116 times)
smalldragoon
Full Member
***
Offline Offline

Posts: 12


« on: Friday 23 September 2011, 07:46:09 pm »

Hi,
Being just a newbie user, I installed the soft on a blade Server.
everything went fine ( I needed to do a CRTL+C during install of packages for spamAssassin at it seems to block forever the install )

Now everything is installed, and I defined an IP address as requested.
when I check the links ( show network links ) , I can see 6 links
1: lo
2 : eth0
3 : eth1
4 : eth2
5 : eth3
6 :br0

When I check the addresses ( show network addresses ) ,
lo : 127.0.0.1, fine
1: lo
2 : eth0   ( link on this card, no prob )
3 : eth1 ( link on this card, no prob )
4 : eth2
5 : eth3
6 :br0 ( "link" and ip define : 10.200.0.254/16)

but can not ping and of course access to the GUI
what am I missing ? anything to activate ?
Thx
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.047 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com