Welcome, Guest. Please login or register.
Did you miss your activation email?
Saturday 02 November 2024, 07:31:57 am

Login with username, password and session length

Visit the Official Endian Bug tracker  HERE
14248 Posts in 4376 Topics by 6515 Members
Latest Member: hulteends
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  Comcast and Uplink - FAILURE
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Comcast and Uplink - FAILURE  (Read 10247 times)
mrvllus
Jr. Member
*
Offline Offline

Posts: 5


« on: Saturday 04 February 2012, 04:10:03 am »

Hello everyone,

I have setup up a EFW in my home, but am unable to get my "main uplink" to connect.  Every time I click on System -> Dashboard and look at the Uplinks section, the status sits at connecting, then changes to failed.  I am using comcast as an ISP here is my hardware setup:

Linksys cable modem -> cisco switch -> EFW -> another switch for home network

Under network configurations:

page 1/8 - chose Ethernet DHCP (Number of interfaces is 2)
page 2/8 - chose network zones -> NONE for blue and orange
page 3/8 - chose correct green NIC (ip address 192.168.110.1 - mask /24 - 255.255.255.0
page 4/8 - chose correct red NIC (left MTU and Spoof Mac blank) - DNS was manual
page 5/8 - looked up comcast DNS primary/sec servers and enter ip
page 6/8 - admin mail (left blank)
page 7/8 apply


I have had a few , who have EFW configured at home, take a look at this and they have said that all other settings looks correct. 

One of my  is using comcast and he said he had to spoof his mac address on page 4/8 of the network setup wizard.  He suggested that I take my laptop and plug it directly into the cable mode, wait for the ip to be assigned and make sure I can browse the internet.  Then do an ipconfig /all and look at the mac address of the laptop and us that on page 4/8 of the network wizard.  Here was his suggestion for hardware:

Linksys cable modem -> EFW -> another switch for home network

I tried this and was not successful. 

The end result is the EFW is up and running, DHCP is working, but I am unable to get out  and browse any sites.

Any ideas?
Logged
mrvllus
Jr. Member
*
Offline Offline

Posts: 5


« Reply #1 on: Saturday 04 February 2012, 04:19:44 am »

I didn't mention I was EFW version using 2.5
Logged
mrvllus
Jr. Member
*
Offline Offline

Posts: 5


« Reply #2 on: Sunday 05 February 2012, 08:11:55 am »

Turns out this was a linksys cable modem issue.  Here are the steps I took to resolve this issue:


unplug cable modem for 30 sec and plug back in
plug my cable modem directly into my laptop
open cmd propt and type ipconfig /all
get the ethernet lan mac address
unplug my laptop and plug into EFW
go into network wizard and on page 4 add spoof the mac address with the one from my laptop


worked like a charm

Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.047 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com