|
Title: Port Forwarding problems Post by: ricos on Sunday 19 July 2009, 08:56:33 pm Hello community
If my English excuses ;D Have problems with the port Forwarding between Endian and my Dream Endian: 10.133.166.4 Dream: 10.133.166.28 I have put down this: UDP Uplink EVERYBODY: 11219 => 10.133.166.28: 11219 11219 Access permits from: 10.133.166.4 (11219) however, it does not work. Does it need additional settings? Does one have a Howto? Thank you 15:41:04 FORWARD:DROP br0 KEY_UDP 10.133.166.28 1046 ff:ff:14:00:03:00 ..121.12 11219 Title: Re: Port Forwarding problems Post by: bayross on Wednesday 28 October 2009, 01:42:10 am Follow this sample and change the ports/protocols as needed....
In Firewall, configure a Destination NAT rule as follows: Access: ANY Uplink Target: ANY Uplink Service HTTP Protocol: TCP Target: 80 Translate to: TYPE IP DNAT Policy: NAT IP: {WEBSERVER IP on GREEN INTERFACE} Port Range: 80 Save and apply rule Then go to Firewall, configure System Access rule as follows: Source Address: {leave blank} Source Interface: RED Service HTTP Protocol: TCP Target: 80 Policy: ACTION "ALLOW" Save and apply and you should be good to go. You will now be able to access the specified webserver externally (Red zone to green zone) *NOTE: It is recommened for security purposes to put Internet facing devices on the DMZ Thanks, Garrett |