Welcome, Guest. Please login or register.
Did you miss your activation email?
Tuesday 24 December 2024, 03:06:19 am

Login with username, password and session length

Download the latest community FREE version  HERE
14262 Posts in 4377 Topics by 6517 Members
Latest Member: Sandro
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  Command to Permanently Change GREEN IP?
0 Members and 2 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Command to Permanently Change GREEN IP?  (Read 15852 times)
jinizishuai
Jr. Member
*
Offline Offline

Posts: 2


« on: Wednesday 08 June 2011, 07:03:11 am »

Hi there,

I had similar problems of this earlier post:  efwsupport.com/index.php?topic=414.0 (sorry that I am not allowed to post clickable links)

However, I don't seem to find the "setup" command under my 2.4.1 EFW installation.

I could do "ifconfig br0" but this does not survive a reboot.

There must be some configuration files that is used to store the GREEN IP address unfortunately I don't find the typical /etc/sysconfig/network-scripts/ifcfg-<dev> files.

Could anyone help me here?
Thanks a lot.

Shi
Logged
jinizishuai
Jr. Member
*
Offline Offline

Posts: 2


« Reply #1 on: Thursday 09 June 2011, 07:08:40 am »

I've finally found it in /var/efw/ethernet.
This should do the work.
Logged
leandroscar
Jr. Member
*
Offline Offline

Posts: 1


« Reply #2 on: Friday 16 September 2011, 05:26:13 am »

Answering the question,
The file is located in / var / EFW / ethernet / settings
Make changes to this file and restart the equipment
and ready
Logged
trymes
Full Member
***
Offline Offline

Posts: 36


« Reply #3 on: Tuesday 20 September 2011, 12:19:53 am »

Wouldn't it make more sense and be easier to use the "Network Configuration" link on the "System" page of the Web interface? It's the link just below "Dashboard" and it will walk you through the network setup.

The only gotcha I found was that the wizard will allow you to enter configuration settings for the RED interface, but the Uplinks entries under "Network - Uplinks" will take precedence over watever you enter in the wizard.

Tom
Logged
tadaog
Jr. Member
*
Offline Offline

Posts: 4


« Reply #4 on: Tuesday 20 September 2011, 11:10:41 pm »

There's a BIG CATCH in doing this by the Network Configuration Wizard, it can only be done completely, so it restarts the configuration and in the meantime, IF WE ARE outside, we lost connection, and if an error occurs, we cannot connect again! So the manual method is much more secure.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.094 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com