EFW Support

In previous versions I configured several Ips in the red interface without problems. In version 3.2.2 I can not do it.
When I try to configure the interface using the network configuration wizard I get the following error:

RED IPs (IP / CIDR)? 10.12.122.10/29 10.12.123.4/24 10.12.123.9/24
Configuration error: Invalid IP / CIDR

An identical configuration worked for me in earlier versions.

I appreciate any help

Hi,

You must write one single IP on a single row (is written there: "Add additional addresses (one IP/Netmask or IP/CIDR per line)"):
10.12.122.10/29
10.12.123.4/24
10.12.123.9/24

BR,
Gabriel

Dear Gabriel,
In the web interface you must write an IP per line, but in console mode we can write several IPs / CIDR separated by spaces.

However using any of the 2 methods endian does not respond after configured with several IP.

Example: I can't access through the green interface to the web interface via port 10443
 
Important note: My Endian FW is in a virtualized environment with PROXMOX. All Interfaces are model Intel E1000 (Using EXSi always worked for me)

I have been trying to upgrade my version 2 to version 3 for a while now.  I also have multiple IP's on the RED interface.  I just backed up the configuration from the version 2 server, restored it on the version 3 server, and it doesn't seem to pass traffic.  It was passing some traffic, as pings to some addresses were going through, but very little else.

I'm wondering if I am experiencing the exact same issue?

I do not know, but it could be ...
In my case when configuring several IPs in the information that shows the console disappears the red interface