Welcome, Guest. Please login or register.
Did you miss your activation email?
Sunday 14 August 2022, 03:29:01 am

Login with username, password and session length

Download the latest community FREE version  HERE
14173 Posts in 4334 Topics by 6325 Members
Latest Member: edegiobbi
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  Version 3.3.12 Blocking IP Addresses
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Version 3.3.12 Blocking IP Addresses  (Read 3897 times)
d072330
Jr. Member
*
Offline Offline

Posts: 2



« on: Thursday 09 December 2021, 05:09:46 am »

I used to be able to block IP addresses when I was running version 2.3.  Now the same instructions for blocking IP addresses does not work.

In the portion of the block rule in the Insert IP section I used to leave blank.  Now when you try to leave the insert IP section blank it give this message.  Will not allow you to save the rule as long as it is blank.   

Invalid target IP address ""

Incoming IP Section:
  • Incoming IP: Zone/VPN/Uplink
  • Select interfaces: Uplink main - IP: All known
  • Service: ANY
  • Protocol: ANY

Translate to Section:
  • Type: IP
  • Insert IP: supposed to be blank but will not allow me to leave blank
  • Port/Range: Blank
  • NAT: NAT

Access From Section:
  • Source Type: Network/IP/Range
  • Filter: DROP
  • Insert network/IPs (one per line): only has one IP at the present moment for testing
  • Position: First

Did this change from version 2.3 to 3.3?

Is there a better way of doing this in version 3.3?

Why can the insert IP not be empty in version 3.3? 
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.043 seconds with 19 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com