Welcome, Guest. Please login or register.
Did you miss your activation email?
Friday 29 March 2024, 12:27:45 am

Login with username, password and session length

Visit the official Endian Community Mailinglist  HERE
14247 Posts in 4376 Topics by 6490 Members
Latest Member: maquino
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  General Support
| | |-+  4 Nic's Endian Box
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: 4 Nic's Endian Box  (Read 6437 times)
NuclearOption
Jr. Member
*
Offline Offline

Posts: 9


« on: Sunday 02 September 2012, 11:12:48 am »

For my current Setup i Have 2 Nics One As the red and the green interface i recently added 2 new i gigabit nic's and i want to set up a vlan for one of them to go to One single computer i have tried just pluging it into the the interface and for some reason i cant get an ip address is there more to this than just plug and play?
Logged
endianupdate
Full Member
***
Offline Offline

Posts: 53


« Reply #1 on: Friday 21 September 2012, 01:55:05 am »

If you have added two additional NICs to the EFW then you would normally set these up as blue and orange zones configured with additional IP subnets, then you can connect the single computer to one of the zones and it will be protected from the other zones by the EFW firewall (if you want to allow traffic between zones you can use the Intra-Zone traffic settings of the EFW firewall).

In this configuration you will not need VLANs to separate the devices.

Hope this helps.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.031 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com