Welcome, Guest. Please login or register.
Did you miss your activation email?
Saturday 02 December 2023, 01:02:01 am

Login with username, password and session length

Download the latest community FREE version  HERE
14237 Posts in 4371 Topics by 6461 Members
Latest Member: devel.tech1
Search:     Advanced search
+  EFW Support
|-+  Support
| |-+  Installation Support
| | |-+  cannot install Endian 3.0 on Hp proliant DL380p G8
0 Members and 0 Guests are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: cannot install Endian 3.0 on Hp proliant DL380p G8  (Read 15324 times)
Rotich
Jr. Member
*
Offline Offline

Posts: 4


« on: Wednesday 01 October 2014, 05:08:40 am »

Iam trying to install Endian 3.0 on HP proliant DL380p g8 but flashes a blue screen when it reaches select language page and does not proceed.what is the workaround?
Logged
mmiat
Sr. Member
****
Offline Offline

Gender: Male
Posts: 236


WWW
« Reply #1 on: Thursday 02 October 2014, 05:20:06 pm »

me too, are you installing from usb? installing from cd solved it
Logged

---------------------
IT Consultant
www.fsw.it
Hardware & Software
Rotich
Jr. Member
*
Offline Offline

Posts: 4


« Reply #2 on: Thursday 02 October 2014, 07:10:05 pm »

Am installing from a CD
Logged
mmiat
Sr. Member
****
Offline Offline

Gender: Male
Posts: 236


WWW
« Reply #3 on: Thursday 02 October 2014, 07:37:12 pm »

press alt+f2 so you can see console, maybe there is some warning
Logged

---------------------
IT Consultant
www.fsw.it
Hardware & Software
Rotich
Jr. Member
*
Offline Offline

Posts: 4


« Reply #4 on: Thursday 02 October 2014, 08:21:12 pm »

when i press alt+f2 i get the error
module usbhid not found
mounting none on /proc/bus/usb failed device or resource busy
running command /bin/mountsource.sh
Logged
Neo
Jr. Member
*
Offline Offline

Posts: 6


« Reply #5 on: Thursday 02 October 2014, 09:53:19 pm »

Hie

What type of a HDD controller is on that server? Is the drive a SATA drive?

If SATA, please access your CMOS setup and change the SATA mode to AHCI and then restart the setup. It should go past the current blue screen.
Logged
Rotich
Jr. Member
*
Offline Offline

Posts: 4


« Reply #6 on: Thursday 16 October 2014, 09:48:42 pm »

After changing from SATA to AHCI i can go past the blue. From there i cannot proceed, i get the error  Error reading target_device.Your hard disk is too small
Logged
jomoryja
Jr. Member
*
Offline Offline

Posts: 9


« Reply #7 on: Friday 17 October 2014, 07:49:57 am »

That probably means that your harddisk controller is not recognized so Endian does not see a harddisk to install onto.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Page created in 0.094 seconds with 18 queries.
Powered by SMF 1.1 RC2 | SMF © 2001-2005, Lewis Media Design by 7dana.com