Set VLAN

[Guest]

[miki22]

Good morning
On my endian I have two zones:

A Green 192.168.1.0/24
One Blue 192.168.10.0/24

We must activated vlan

We see in the INTERFACE menu we can set VLANS

We click ADD to VLAN we set interface green + set id = 1 + set green zone

When we set this parameters the green interface go ko

we have reinstalla Endian 3.3.2 and we had try with blue zone:

We click ADD to VLAN we set interface blue + set id = 2 + set blue zone

When we set this parameters blue go ko


anyone can help us?

NB - In our firewall menu we have set the firewall inter-zone active from blue to green

is that a problem?

[justme]

this is normal, you need to have at least one vlan in place, once you enable it, the untagged traffic will be dropped

so in your case, if you enable vlan 1, all traffic needs to be tagged using vlan 1, the same for blue zone, but with tag 2

[miki22]

ok i try to review the problem, thanks a lot for the reply!

[miki22]

ok i tried and everything works thanks.

I write what we have done in favor of other users:

Basically, we connected a switch after the firewall with a trunk port

then we put the vlan on the switch

and we connected the computers to the untagged vlan

Everything works perfectly!

Thanks